The maximum working pressure has been increased from that of conventional air filters, enabling use with medium-pressure specifications such as medium-pressure compressors.
CKD Filter Type: Air Filter Medium Pressure Type Oil Mist Medium Pressure Type Air Filter Medium Pressure TypeFM3000/FM4000/FM6000/FM8000 Series Medium pressure specifications for F3000 to 8000 Series Model FM3000 FM4000 FM6000 FM8000 Appearance Working Fluid Compressed Air Max. Working Pressure(MPa) 1.6 Withstanding Pressure(MPa) 2.4 Ambient Temperature( ° C) -5 to 60 ( no freezing ) Fluid Temperature( ° C) 5 to 60 Filtration Rating( ·m) 5 or 0.3 Drain Capacity(cm3) 45 80 80 80 *Note1 Port Size 1/4, 3/8 1/4, 3/8, 1/2 3/4, 1 3/4, 1 Product Weight(kg) 0.5 0.55 1.0 1.26 *Note1: Drainage accumulates up to 170 cm3 only with the manual drain cock. Oil Mist Filter Medium Pressure TypeMM3000/MM4000/MM6000/MM8000 Series Medium pressure specifications for M3000 to 8000 Series Model MM3000 MM4000 MM6000 MM8000 Appearance Working Fluid Compressed Air Max. Working Pressure(MPa) 0.1 to 1.6 Withstanding Pressure(MPa) 2.4 Drain Capacity(cm3) 45 80 80 80 Port Size 1/4, 3/8 1/4, 3/8, 1/2 3/4, 1 3/4, 1 Product Weight(kg) 0.35 0.55 1.0 1.48 Mantel Option Name Blank (M Type) S (S Type) X (X Type) Treating Flow Rate L/min (ANR)Primary side pressure 1.4MPaPressure Drop 0.01MPa MM3000 490 610 610 MM4000 1130 1370 1370 MM6000 1740 1920 1920 MM8000 3560 3980 3980 Ambient Temperature( ° C) -5 to 60 (no freezing) -5 to 30 (no freezing) Fluid Temperature( ° C) 5 to 60 5 to 30 Filtration Rating( ·m) 0.01 (nominal) 0.03 Absorption by activated charcoal*Note3 Secondary Side Oil Concentration(mg/m3) 0.01 or less*Note1, Note2 0.5 or less*Note1 0.003 or less*Note1, Note4 Mantle (Element) Change One year (6000 hours) or pressure drop 0.1MPa *Note5 *Note1: At primary side oil concentration 30mg/m3, inlet air temperature 21 °C. *Note2: Install an S oil mist filter as a pre-filter on the preliminary side to prevent early clogging. *Note3: Install an F Series air filter or M Series or M or S oil mist filter on the secondary side to prevent active carbon particles from reaching the secondary side. *Note4: When oil mist filter (M type of M series) is installed on the primary side. *Note5: X mantle (element) replacement is determined by odor concentration in compressed air, and cannot be clearly indicated. Time from initial installation to when an oil odor is noted is the effective deodorization time. Replace the mantle (element) regularly during this time. The primary air temperature must be 30 °C or less. Deodorizing decreases if the temperature is high, so provide measures to dissipate heat.